Also – did you also try the standard b43 driver? ScrollerBlaster 1 1 9. Firmware is not packaged by the Debian Project. No such file or directory” error message. Perhaps the wireless card was removed at that point. Connect your laptop with a wired connection and test your internet connection works.
|Date Added:||25 February 2011|
|File Size:||29.76 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Firmware from userspace is required for device operation.
Broadcom 43xx wireless devices
Sign up using Facebook. Also – did you also try the standard b43 driver? Just add ” contrib non-free” to the end of your existing line. You must go to http: Debian 9 “stretch” deb http: Sign up or log in Sign up using Google. Removed from Linux at 2. This legaacy earned notable question during my legact month absence from this forum. I successfully installed sudo apt-get install firmware-b43legacy-installer In the nm-applet I now get Wireless networks device not ready firmware missing I open up Additional Drivers, but the list is empty.
Firmware is not packaged by the Debian Project. Step 4 works perfectly. ScrollerBlaster 1 1 9.
I short, step 3 failed. I opted for the legacy firmware installer, following instructions for internet install to the letter with no errors.
OpenWrt Project: b43 legacy
Broadcom Corporation BCM So to answer first question, I can’t remember if there was a prompt is that because it’s lubuntu?
To answer your second question, it is bb43 installed since I re-installed firmware-binstaller. Can you add the whole line from dmesg that has this firmware error in it? My problem was that my card was reported as BCM by lspci.
bcm43xx – Debian Wiki
No such file or directory” error message. There is no b43 directory.
When it is installing, it reports a slightly different card: Also, in case you don’t have any internet access on the machine in question, check out my related answer. I wrongly installed the legacy firmware. An Internet connection is required. Remove the blegacy package you have installed.
I legay pasted the relevant stuff you asked for in the post. The relevant driver has built-in logic to probe the actual chip, for example: All that is required is the firmwareinstaller instead.